Voland 1992, Why throw it away, it will still serve for a long time. I upload it and get back in response File too large, try again Help please flash the router under the interface mts. Now there is no modem, DHCP will be picked up from your main router (to which the modem should be connected via cable)Īnd if there is a desire to climb in the modem settings, then connect to the WiFi point of the config and go 192.168.1.2 ![]() ![]() ![]() Sorry for the delay and so the procedure is necessary to turn on the modem in bridge modeĢ) flashing the modem on the MTS-Sov firmware (it is possible to enable the bridge mode)Ĥ) configure the ip address of the modem 192.168.1.2 (well, or what is your network)Ĥ) go to the WLAN settings and configure our WiFi, it is very important to assign SSID1ĥ) further customize SSID2I called it config, in the future through it we will connect to configure the modem (well, or for writing instructions :))Ħ) go to the "binding to the bridge" and tick the interfaces that will work in bridge mode, it is important do not mark SSID2otherwise it will no longer be possible to connect to the modem, only reset to factory settings
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |